How to Pair the Autowatch Ghost 2 With Your Phone

Pairing the Autowatch Ghost 2 immobilizer with your phone allows the system to recognize you automatically and simplifies daily use while maintaining full vehicle security. When paired correctly, your phone acts as a secure tag, reducing the need to enter your PIN code every time you drive.

This guide explains the exact process, including how to properly enter learning mode, which is essential for successful pairing.

What You Need Before Pairing

Before starting, confirm the following:

Ghost 2 is installed and fully operational
You have your programmed PIN code
You have your Ghost card, and the Bluetooth pairing code has been scratched and revealed
Your smartphone has Bluetooth enabled
The Autowatch Ghost app is installed

Step-by-Step: How to Pair Ghost 2 With Your Phone

Follow each step carefully. Sequence and timing are critical.

1. Turn the Ignition On

Switch the ignition to the ON position without starting the engine. This activates the Ghost system.

2. Enter Your PIN Code

Using your programmed vehicle buttons, enter your PIN code. Once entered correctly, the system will disarm.

3. Enter Learning Mode

After disarming the system, you must place the Ghost 2 into learning mode to allow pairing.

Press and hold the accelerator pedal fully to the floor or pull the high beam lever, depending on your vehicle configuration. While holding this input, enter your PIN code again using the programmed buttons.

If performed correctly, the system will confirm entry into learning mode with an intermittent beeping sound.

Once you hear the beeping, the system is ready to pair with your phone.

4. Open the Ghost App

Open the Autowatch Ghost app on your smartphone.

Ensure the following:

Bluetooth is turned ON
All permissions are accepted

5. Initiate Pairing

With the app open, press your service button once.

A notification will appear on your phone prompting you to proceed with pairing.

6. Enter the Bluetooth Pairing Code

Enter the unique Bluetooth pairing code from your Ghost card into the app.

Confirm the input to complete the connection.

Once accepted, your phone is successfully paired with the Ghost 2 system.

How the System Works After Pairing

After pairing is complete:

When your phone is present, the system will automatically disarm, provided the app is active and the app button is ON (orange).
When your phone is not detected, the system requires your PIN code

This ensures the vehicle remains protected at all times while improving convenience.

Best Practices

To maintain consistent performance:

Keep Bluetooth enabled while using the vehicle
Ensure the app button is ON (orange) so the system can automatically disarm
Ensure your phone remains charged
Always remember your PIN code as a backup
Re-pair the system if you change or reset your phone

Troubleshooting Pairing Issues

If pairing does not complete successfully:

Confirm Bluetooth is enabled and functioning
Restart the mobile application
Repeat the learning mode process carefully
Stay within close proximity to the vehicle

Monty’s Locksmith: A Leader in Vehicle Security

Entrusting your vehicle’s security to Monty’s Locksmith means choosing a company that is not only a leader in automotive locksmith services but also deeply committed to customer satisfaction, as evidenced by our extensive positive reviews and CAA affiliation.

Monty’s Locksmith, in partnership with CAA, offers you not just a product but a solution to elevate your vehicle’s safety. Don’t miss out on the advantages of an Ghost2 anti-theft device—make the smart choice today and enjoy the added security in every journey you take. Your car deserves it, and so do you!